Search found 3493 matches

by Aaron
Wed May 05, 2021 2:35 pm
Forum: Tech Support
Topic: ym1510
Replies: 4
Views: 30

Re: ym1510

They will all have the 3 bolt flange.
https://www.hoyetractor.com/CTGY/YM1510DIFFLOCK.htm
by Aaron
Wed May 05, 2021 7:15 am
Forum: Tech Support
Topic: ym1510
Replies: 4
Views: 30

Re: ym1510

All of the YM1510 tractors will have the same rear axle. Are you sure you have a YM1510? https://www.hoyetractor.com/CTGY/YM1510REARAXLE.htm To replace the rear axle you will remove the PTO (shown in video below) and then remove the snap rings holding the axle in. https://www.hoyetractor.com/PTOSeal...
by Aaron
Tue May 04, 2021 3:59 pm
Forum: Tech Support
Topic: YM 2002D electrical problem
Replies: 4
Views: 62

Re: YM 2002D electrical problem

I agree. If you have power going in but not out then it about has to be the switch.
by Aaron
Tue May 04, 2021 12:45 pm
Forum: Tech Support
Topic: Yanmar 2000d
Replies: 1
Views: 18

Re: Yanmar 2000d

It sounds like the loader is plumbed wrong. Is it plumbed like shown in the link below?
https://www.hoyetractor.com/loaderinstall.htm
by Aaron
Tue May 04, 2021 12:44 pm
Forum: Tech Support
Topic: Need help with powershift output shaft
Replies: 2
Views: 36

Re: Need help with powershift output shaft

We were actually going to get that shaft reproduced a few years back. We sent our last one off to a machine shop to make it for us and they lost it and then went out of business. I should have a complete used pump left if you are interested but they are very expensive pieces. Click the contact us li...
by Aaron
Fri Apr 30, 2021 1:38 pm
Forum: Tech Support
Topic: sa 324 wont start
Replies: 2
Views: 68

Re: sa 324 wont start

Sounds like it was not low enough to run out of fuel but, just to double check- Have you gone through the bleeding procedure? https://www.hoyetractor.com/FuelFilterVideo.htm Im not real familiar with the newer Yanmars but Im betting you have an electric fuel pump - can you hear it running with the k...
by Aaron
Fri Apr 30, 2021 12:31 pm
Forum: Tech Support
Topic: Fx20D won't start after overheat
Replies: 13
Views: 171

Re: Fx20D won't start after overheat

Harbor Freight used to sell a diesel compression tester kit that had a bunch of adapters and I think one of those fit the F series but can't remember for sure.
by Aaron
Fri Apr 30, 2021 12:28 pm
Forum: Tech Support
Topic: 4wd Front Axle/ Steering Issue - 1401D
Replies: 7
Views: 2108

Re: 4wd Front Axle/ Steering Issue - 1401D

Very nice!
by Aaron
Thu Apr 29, 2021 11:57 am
Forum: Tech Support
Topic: Fx20D won't start after overheat
Replies: 13
Views: 171

Re: Fx20D won't start after overheat

It is pretty easy on that model since it has a glow plug. You just unscrew the glow plug and screw the adapter in the hole.

I would also be sure the electric fuel shutoff actuator is moving. It is right behind the injection pump. It just pulls a little lever when you turn the key on.
by Aaron
Thu Apr 29, 2021 7:44 am
Forum: Tech Support
Topic: F255 Clutch Bearing Carrier
Replies: 4
Views: 105

Re: F255 Clutch Bearing Carrier

Winston is correct (as usual). :D
by Aaron
Thu Apr 29, 2021 7:43 am
Forum: Tech Support
Topic: Replacement starter connection
Replies: 2
Views: 70

Re: Replacement starter connection

There were no support tickets made under that name or email address. Your diagram is correct. 2 big rings go on big post. Small ring needs a spade end and goes to the black plug. The biggest wire is power from the battery. The mid sized wire powers the dash. The small wire is from the ignition switc...
by Aaron
Thu Apr 29, 2021 7:40 am
Forum: Tech Support
Topic: YM 2002D electrical problem
Replies: 4
Views: 62

Re: YM 2002D electrical problem

The 2002 has a fusible link in the bigger wire going from the starter to the ignition switch (which then powers the fuse box). It will look like:
https://www.hoyetractor.com/PROD/WH-455.htm
by Aaron
Thu Apr 29, 2021 7:38 am
Forum: Tech Support
Topic: Fx20D won't start after overheat
Replies: 13
Views: 171

Re: Fx20D won't start after overheat

That seems to be the weak spot on those tractors. Pretty much all of the salvage tractors that we have bought were overheated and ended up with egged cylinders and very low compression. I would do a compression test to confirm.
by Aaron
Tue Apr 27, 2021 9:14 am
Forum: Tech Support
Topic: Snow blower reality on ym2000
Replies: 1
Views: 69

Re: Snow blower reality on ym2000

I'd love to be able to offer some advice but I just don't have much snow experience. What little snow we get here is usually gone by the afternoon. Hopefully someone else will chime in with a suggestion.
by Aaron
Tue Apr 27, 2021 9:09 am
Forum: Tech Support
Topic: Torque Specs for 2220D Tractor
Replies: 2
Views: 87

Re: Torque Specs for 2220D Tractor

The 2220 engine will not have anything special. I would recommend the link below though.
https://www.hoyetractor.com/head-gasket.htm

1.jpg
1.jpg (28.41 KiB) Viewed 85 times

Go to advanced search