Valve timing 2210

Post your questions or problems you are haviing with your Yanmar tractor here.

Moderator: Aaron

MizzouBeach
Volunteer Poster
Posts: 53
Joined: Mon Oct 08, 2018 9:44 am

Valve timing 2210

Postby MizzouBeach » Sun May 10, 2020 10:48 am

I put a new crankshaft in my motor, and after disassembling it, realized I hadn't looked at the position of the cam gear in relation to the crank gear before taking them off. I looked in my manual, but couldn't find anything addressing this. If i mate them so that the 0 on the cam gear fits between the two 0's on the crank gear, I presume that will give me the correct valve (and injector) timing. Is this correct?

MizzouBeach
Volunteer Poster
Posts: 53
Joined: Mon Oct 08, 2018 9:44 am

Re: Valve timing 2210 + injector timing

Postby MizzouBeach » Sun May 10, 2020 11:46 am

Never mind-I found it... However, speaking of timing, how about injection timing? The manual just says that Yanmar injectors don't go "out of time", so no need for adjustment. But what if some time in the past someone had fiddled with it, or replaced the pump? I looked for an article about it, but couldn't find one. I know that the shims are the method of changing the timing, but is there a way to find out if they are pumping at the proper time? I've got the motor sitting on the bench, so now is the perfect time, so to speak.

winston
Volunteer Poster
Posts: 5433
Joined: Mon Feb 01, 2010 7:29 am
Location: North East Texas

Re: Valve timing 2210

Postby winston » Sun May 10, 2020 12:44 pm

I doubt you need to do this but here is the I&T instructions. Takes two posts to get them all and they are out of order. Maybe you can figure it out.
Attachments
2020-05-10-013201_2.jpg
2020-05-10-013201_2.jpg (166.31 KiB) Viewed 499 times
2020-05-10-013201.jpg
2020-05-10-013201.jpg (225.75 KiB) Viewed 499 times

winston
Volunteer Poster
Posts: 5433
Joined: Mon Feb 01, 2010 7:29 am
Location: North East Texas

Re: Valve timing 2210

Postby winston » Sun May 10, 2020 12:45 pm

Picture.
2020-05-10-013201_3.jpg
2020-05-10-013201_3.jpg (195.55 KiB) Viewed 499 times

MizzouBeach
Volunteer Poster
Posts: 53
Joined: Mon Oct 08, 2018 9:44 am

Re: Valve timing 2210

Postby MizzouBeach » Sun May 10, 2020 7:29 pm

Thanks, Winston, for responding on a Sunday afternoon! I'll take a look and see.


Return to “Tech Support”

Who is online

Users browsing this forum: No registered users and 40 guests