Ball bearings on 4x4 axle shaft

Post your questions or problems you are haviing with your Yanmar tractor here.

Moderator: Aaron

beartrace
Volunteer Poster
Posts: 5
Joined: Sat Oct 17, 2015 7:21 pm

Ball bearings on 4x4 axle shaft

Postby beartrace » Sat Jun 29, 2019 3:08 pm

Doing engine R&R. When separating the ball bearings in the forward 4x4 shaft fell out. How and where do I reinstall? Can I install the engine then later install the 4x4 shaft?

Thank you in advance.

Aaron
Site Administrator
Posts: 2941
Joined: Thu Jul 26, 2007 12:39 pm
Location: Iowa Park, TX

Re: Ball bearings on 4x4 axle shaft

Postby Aaron » Sat Jun 29, 2019 5:45 pm

The 6 little balls on each end are #34 in the link below
https://www.hoyetractor.com/CTGY/16104WDINT.htm

Yes you can re-install that shaft after everything else is back together.

Use grease to hold the balls in place while you re-install.

beartrace
Volunteer Poster
Posts: 5
Joined: Sat Oct 17, 2015 7:21 pm

Re: Ball bearings on 4x4 axle shaft

Postby beartrace » Sat Jun 29, 2019 6:41 pm

Ok, thanks, but I am still uncertain where they go.....

winston
Volunteer Poster
Posts: 5005
Joined: Mon Feb 01, 2010 7:29 am
Location: North East Texas

Re: Ball bearings on 4x4 axle shaft

Postby winston » Sun Jun 30, 2019 5:30 am



Return to “Tech Support”

Who is online

Users browsing this forum: No registered users and 10 guests