Yanmar RS1200 Question

Post your questions or problems you are haviing with your Yanmar tractor here.

Moderator: Aaron

rgtmcc
Volunteer Poster
Posts: 2
Joined: Wed Sep 06, 2017 9:54 pm

Yanmar RS1200 Question

Postby rgtmcc » Wed Sep 06, 2017 9:58 pm

Can any one supply me with a schematic view of an RS1200 rotory tiller?
Thank you!

winston
Volunteer Poster
Posts: 4230
Joined: Mon Feb 01, 2010 7:29 am
Location: North East Texas

Re: Yanmar RS1200 Question

Postby winston » Thu Sep 07, 2017 8:51 am

Don't have that one but yours will be similar to this. https://static.squarespace.com/static/5 ... tiller.pdf

rgtmcc
Volunteer Poster
Posts: 2
Joined: Wed Sep 06, 2017 9:54 pm

Re: Yanmar RS1200 Question

Postby rgtmcc » Thu Sep 07, 2017 2:15 pm

Thanks for that but the drive to the lower shaft with the tines is different. The problem I have is there is a bolt that locks the inner & outer shafts that the tines are on & it keep snapping with very little work. Is there a special bolt?

winston
Volunteer Poster
Posts: 4230
Joined: Mon Feb 01, 2010 7:29 am
Location: North East Texas

Re: Yanmar RS1200 Question

Postby winston » Thu Sep 07, 2017 3:09 pm

might try typing in tiller pin in the search box above.

alan
Volunteer Poster
Posts: 2665
Joined: Sat Oct 06, 2007 6:25 am
Location: West of Toronto

Re: Yanmar RS1200 Question

Postby alan » Thu Sep 07, 2017 8:03 pm

You could try a higher-grade bolt. The grade code should be on the head. Don't go too high because if something's going to snap, it had best be that bolt.


Return to “Tech Support”

Who is online

Users browsing this forum: No registered users and 5 guests