Post your questions or problems you are haviing with your Yanmar tractor here.
4 posts • Page 1 of 1
- Volunteer Poster
- Posts: 12
- Joined: Tue Jun 27, 2017 12:35 pm
- Location: Upstate South Carolina
What is the length specification for both the engine oil and the hydraulic dipstick for a YMN 3810D, including the high/low markings on each the stick?
I don't recall seeing that printed, and it might be hard to find another one of that model to measure. Hyd isn't that exact -- just look down and fill to within about 2" of the opening. For engine, drain and fill with the exact capacity (if you can find that out). That's "full" and "add" would be about a half-inch lower.
Who is online
Users browsing this forum: No registered users and 6 guests