Yanmar Tractor Support Message Board

Hello all, the bearing failed on my tiller. Thank goodness it didn’t hurt the shaft. I ordered a bearing from Hoye but as I was trying to remove it I snapped off the bolt that screws into the end of the shaft. Hoping to drill it and get it out after soaking overnight in kroil.

Can anyone tell me the bolt spec? I need to find a replacement. I assume it is just a plain metric bolt?

Greg

26116-120282, 12mm-28

Thanks Winston.

Picked up a bolt. The broken off part is being stubborn. Going to have to put some heat on it I guess.

Greg