Hand throttle won't hold position

Post your questions or problems you are haviing with your Yanmar tractor here.

Moderator: Aaron

tomrice4k
Volunteer Poster
Posts: 1
Joined: Thu Jul 23, 2020 2:16 pm

Hand throttle won't hold position

Postby tomrice4k » Thu Jul 23, 2020 3:18 pm

The hand throttle on my YM226D will not hold position. I set the throttle where I want it and it eventually moves back and drops the RPM. Is there a way to adjust the tension on the throttle mechanism so it holds position?

winston
Volunteer Poster
Posts: 5612
Joined: Mon Feb 01, 2010 7:29 am
Location: North East Texas

Re: Hand throttle won't hold position

Postby winston » Fri Jul 24, 2020 1:47 pm

Make sure all the parts shown are intact on yours. If so, you can loosen off the outer double nut (17) and then tighten the inner until adequate friction is applied to hold the handle as set. Then tighten the outer locknut.
Attachments
2020-07-24-024411.jpg
2020-07-24-024411.jpg (150.7 KiB) Viewed 1004 times

GBuford4372
Volunteer Poster
Posts: 76
Joined: Tue Jul 07, 2020 4:37 pm

Re: Hand throttle won't hold position

Postby GBuford4372 » Sun Aug 16, 2020 5:59 am

Just had this exact problem. Friction washer (#5) was missing. Ordered it for $2.82 and fixed her right up. Also make sure you have the conical washer (#1). All this is very easily accessible if you remove the front panel, at least on mine. Yours may be a little different. Good luck


Return to “Tech Support”

Who is online

Users browsing this forum: Bing [Bot] and 20 guests