Ym2000 Hydraulic Issues

Post your questions or problems you are haviing with your Yanmar tractor here.

Moderator: Aaron

Volunteer Poster
Posts: 1
Joined: Sat Jun 13, 2020 6:53 am

Ym2000 Hydraulic Issues

Postby rbetts » Sat Jun 13, 2020 7:00 am

I’ve recently purchased a Yanmar YM2000. Perfect tractor, very pleased so far. Recently I was making adjustments to how my bushhog was being lifted (slightly unlevel) and some wheel adjustments to get rear of bushhog more ground clearance. The problem now is the hydraulics will only hold an up position. The handle slowly drops down. I’ve drained fluid , cleaned filter screen. I do not see anything visual here, where do I start?

Volunteer Poster
Posts: 5441
Joined: Mon Feb 01, 2010 7:29 am
Location: North East Texas

Re: Ym2000 Hydraulic Issues

Postby winston » Sun Jun 14, 2020 5:12 am

I am not fully understanding. You say the handle (#49) slowly drops down. Notice the line of hardware that friction washer #58 is on. If all that hardware is intact you might need to tighten the double nuts (#s 60 & 61) a bit to put more resistance on the handles movement.
16-THREE POINT CONTROLS.jpg (111.05 KiB) Viewed 162 times

Return to “Tech Support”

Who is online

Users browsing this forum: No registered users and 38 guests