Search found 486 matches

by Carey
Tue Feb 09, 2016 5:58 pm
Forum: Tech Support
Topic: Ym1500 will not start
Replies: 15
Views: 8083

Re: Ym1500 will not start

Sounds as though that when you ran out of fuel you sucked up so much dirt and debris, Jelled fuel, Water and it about clogged your Fuel Filter. Did you replace the FUEL FILTER? No mention that you did. When you bleed it you get just enough fuel to the pump to get it to run for a few minutes. Very Ty...
by Carey
Sun Feb 07, 2016 12:13 am
Forum: Tech Support
Topic: 2210 Electrical Issue
Replies: 9
Views: 5179

Re: 2210 Electrical Issue

I agree that you need a Volt Meter. With the charge light on you may not be charging. Harbour Frieght you can pick one up Cheap. FWIW. If I leave my Battery Charger on and jump start my Ym2000 my charge light will stay on until I remove it.
by Carey
Tue Feb 02, 2016 3:26 pm
Forum: Tech Support
Topic: 2210 Electrical Issue
Replies: 9
Views: 5179

Re: 2210 Electrical Issue

Have both Regulators on mine. The Org. Regulator was left in the dash. No big deal. The Solid State is Zip tied to the Steering shaft behind the dash. Found the problem finally. Loose wire connection to the fuse box. Corrected that and curious checked the Org. Reg. and it works fine. So now I have b...
by Carey
Mon Feb 01, 2016 12:02 pm
Forum: Tech Support
Topic: 2210 Electrical Issue
Replies: 9
Views: 5179

Re: 2210 Electrical Issue

How the regulator is still working properly smoking like it is I would be amazed also. Take the alternator to a Automotive parts store and have it checked while your at it. To Blow all the Fuses and the Regulator smoking you have a bad problem somewhere. Alternator,Regulator possibly both. Check you...
by Carey
Fri Jan 15, 2016 7:37 am
Forum: Tech Support
Topic: 2000,diesel wont stay in high range keepps popping out
Replies: 3
Views: 2847

Re: 2000,diesel wont stay in high range keepps popping out

#3 Aaron posted was the problem I had with my 2000. Only did it in 2nd Gear at High RPM's. Finally was able to get all the Rust and Debris cleared out and loosened up, now it stays in Gear. 20 & 43 on the Parts Dia. I believe. I really enjoy using 2nd. Gear when I mowing with the FM..
by Carey
Sun Sep 01, 2013 7:31 pm
Forum: Tech Support
Topic: ym2000 three point lift
Replies: 9
Views: 5455

Re: ym2000 three point lift

This is a pic. of my YM2000. It should help.
by Carey
Thu Jun 27, 2013 2:40 pm
Forum: Tech Support
Topic: Engine loses power after about one hour of usage with a load
Replies: 27
Views: 18414

Re: Engine loses power after about one hour of usage with a

I was told Factory The TC 4145 comes on the 140,147,186,180,187,226,330,336,2210,2500,2610,3000,3810 way to many different models not to be. and No Screen Needed! And way to many more models not to make one for them. I believe FT-22 is to small for it to work correctly so they had to use your Fancye...
by Carey
Thu Jun 27, 2013 7:27 am
Forum: Tech Support
Topic: Engine loses power after about one hour of usage with a load
Replies: 27
Views: 18414

Re: Engine loses power after about one hour of usage with a

Poster has a 330. Cap and gauge on a226? There is a Cap and Filter posted by T- George. 12.5"? I guess I don't understand :roll:
by Carey
Wed Jun 26, 2013 1:32 pm
Forum: Tech Support
Topic: Engine loses power after about one hour of usage with a load
Replies: 27
Views: 18414

Re: Engine loses power after about one hour of usage with a

Diesel is diesel, use whatever is available. Farm diesel is just a little cheaper. Sounds like you have debris in the tank, blocking the outlet. I would run it down, drain the fuel and swab out the bottom. Do you have this screen? http://www.hoyetractor.com/mm5/merchant.mvc?Screen=PROD&Store_Co...
by Carey
Tue Jun 25, 2013 7:40 am
Forum: Tech Support
Topic: Engine loses power after about one hour of usage with a load
Replies: 27
Views: 18414

Re: Engine loses power after about one hour of usage with a

When I bought my 2000 and was going through it Fluids, Filter etc. I drained my Tank and cleaned it. I filled it up and was using it. It was new to me and if I recall I stopped to check everything. It was operating Perfect and I just wanted to check my Radiator overflow bottle. It was fine the Coola...
by Carey
Sat Jun 22, 2013 7:41 am
Forum: Tech Support
Topic: Yanmar 2700 ignition key will turn but no fire
Replies: 8
Views: 5907

Re: Yanmar 2700 ignition key will turn but no fire

I took the Starter & Alt. to a big chain auto parts and had them checked. Alt.and Slolenoid was good but Starter Motor was bad. It was a easy fix on the Starter Motor just by Reversing and Cleaning the Brushes. Lasted a couple of Yrs. until I did have to rebuild it. I can recall the man at a loc...
by Carey
Fri Jun 21, 2013 12:42 pm
Forum: Tech Support
Topic: Yanmar 2700 ignition key will turn but no fire
Replies: 8
Views: 5907

Re: Yanmar 2700 ignition key will turn but no fire

I had a Chrg.prob. yrs. ago that I had to test everything both types Reg. Alt, New Battery Cables you name it. Finally found it. On the Fuse box that your discribing sounds like the same type I have. On the Back were the Wire's from the harness attach check to make sure there clean and tight. It was...
by Carey
Wed Jun 19, 2013 12:23 pm
Forum: Tech Support
Topic: rebuilt engine on 2000
Replies: 14
Views: 6581

Re: rebuilt engine on 2000

If it was mine this is what I would check first http://www.hoyetractor.com/support/know ... article=43
and run a compression Chk. while you have the Inj. out.
by Carey
Tue Jun 18, 2013 8:50 pm
Forum: Tech Support
Topic: ym2000 3point won't raise up.
Replies: 3
Views: 3399

Re: ym2000 3point won't raise up.

The dark Green Triangle is the Filter and the drain plug is just below it. Be careful with the o-ring and cleaning the screen. Jd 303 or eqv. for the Hyd. fluid.

Go to advanced search